VEGASWING, VEGAVIB, VEGAWAVE: Point level measurement with vibrating level switches

In point level measurement with vibrating level switches, a rod or a fork is set vibrating. When the vibrating probe comes into contact with the medium, the vibration changes and the vibrating level switch outputs a switching command. Vibrating level switches are used as overfill protection devices or low-level indicators in liquids as well as in granular and powdery bulk solids.
 
The advantages

• Vibrating level switches are easy to install
• Setup and commissioning is possible without medium
• Reliable point level measurement – independent of installation position, pressure, temperature, foam, viscosity and grain size

ACIDIC UNIVERSAL LEVEL SWITCH FOR USE IN ALL LIQUIDS - VEGASWING 61 | Dry Run Protection or Pump Protection in Vessels and Pipeline

HOT OILS AND LIQUIDS LEVEL SWITCH VEGASWING 66 | High Temperature Up To 450°C and High Pressure Switch

LEVEL LIQUIDS DETECTION VEGASWING 63 | Detection for Dry Run or Pump Protection | Chemical or Non Chemical Switch

POWDERS AND FINE-GRAINED LEVEL SWITCH - VEGAWAVE 61 | Level Switch for All Adhesive and Abrasive Products

TOP AND SIDE MOUNTING LEVEL SWITCH - VEGAWAVE 63 | Easy Installation with Universal Power Supply

FINE AND GRANULAR LEVEL SWITCH - VEGAVIB 61 | For Flour, Sugar, Cements Level Detection

SOLIDS IN WATER LEVEL DETECTION - VEGAVIB 63 | Level Switch in Minimum and Maximum Control

PLASTIC FINE AND COARSE-GRAINED LEVEL CONTROL - VEGAVIB 62 | Reliable and Low Cost

ADHESIVE AND ABRASIVE ALL POWDERS AND FINE-GRAINED VEGAWAVE 62 | Low Cost and Easy Installation

UNIVERSAL LEVEL SWITCH IN LIQUIDS WITH SMALL DIMENSIONS - VEGASWING 51 | Empty and Full Pump Protection

VEGAWAVE S61

VEGAVIB S61